General Use,A short introduction,Program Execution,Zero Point Setup,Open a file and 3D display,Getting started with the software,Setup,Hardware,Firmware Update,Installing Additional Options,Backup,Function Check,Parameter Settings,User Login,Initial Operation,Software Setup,CncPod Installation,System Requirements,User Interface,Configuration Menu,Hotkeys,GUI-Settings,Calibration – PWM,Language,User,Macros,Tools,Offsets,Machine,File-Menu,Quit,Export settings,Import Drawing,Recent files,Open NC-File,Menu,Help Menu,About...,Help,Reference Manuel,User Manuel,Support Menu,Logfile Options,Send Request,Updates,User Menu,Logout,Login,Software License,Import settings,Custom Screen,Diagnostics Screen,Setup Screen,Program Screen




Flexibly adapt the machine with macros

The controls can be adjusted by programming so-called Macros flexibly adapted to various machines. Macros are short programs written in an expanded G-Code programming language and is implemented if special commands such as automatic tool changing (M6) are executed.

Macros define the reaction of the control for a command. Macros are also available, which are run at specific times or during specific events, such as for example the boot macro which runs during the booting of the control software.

Macro directory

If the machine is supposed to switch operating modes, altering the macro directory simply between two or more macro sets can be done without altering all the macros individually.

By right clicking on the „Edit“ button a text editor will launch and you can edit the program text in the individual macros. This is only recommended for advanced users and is described in the separate reference handbook.

Copyright © 2017 by Benezan Electronics. All Rights Reserved